Click through the photo gallery below to follow the Komatsu H2W300 servo press' journey from the back of a truck to Manor's production floor.

  • The servo press rolls onto Manor property in the early morning hours.
  • The size and weight of the new
    Komatsu H2W300 solid frame servo-driven press requires it to be trucked in as a “Super Load”.
  • The servo press gets prepared to be lifted off of the truck.
  • A portable gantry crane
    gets the servo press airborne to allow the truck to leave Manor’s premises.
  • Getting the servo press into the shop
    requires a lot of careful maneuvering - it's no small piece of equipment
  • Even when perfectly aligned,
    there isn’t a huge tolerance for the rigging team to work with.
  • The press enters its new home in Manor’s facilities.
  • The forklift is manned with careful
    concentration as it maneuvers alongside the other presses.
  • The rigging team works together to guide the press without causing any damage.
  • The meticulous planning pays off.
    It’s a close fit, but everything moves smoothly.
  • The press is prepped for its journey to its upright position.
  • The crane starts the slow,
    deliberate process of lifting the servo press to its upright position.
  • The forklift takes over
    the job as the servo press gets closer to its standing position.
  • Blocks are set up
    to ease the final steps of the uprighting process.
  • Manor’s very first 330 ton
    servo press stands upright on the floor for the very first time.
  • Our new Komatsu H2W300
    servo press stands in location with guarding installed, as the first test-runs begin.

Servo Press Specifications

Model

H2W300

Type

S

Max. Capacity U.S.ton

330

Rating Point in.

0.24

StrokeRotation
Pendulum
in.
in.

11.8
4.72

SpeedRotation
Pendulum
s.p.m.
s.p.m.

~40
~55

Shutheight in.

23.6

Slide Adjustment in.

7.9

Slide-Width in.

82.7

Slide-Depth in.

47.2

Bolster-Width in.

94.5

Bolster-Depth in.

47.2

Bolster-Thickness in.

7.9

Max.Upper Die/Tooling lb.

4,400

Main Motor Kw(qty)

60(2)
Get an Engineering Review of My Part

Would you like an Engineer to Review Your Design?

Get a free consultation with one of our design and manufactureing engineers to assist you with your tool design and production plan.